System information

12-14 Adit 3000 CLI - Release 1.6
Configuration - Serial Interface Mode
multilink-group
multilink-group
Use the Serial Interface multilink-group command to configure a MLPPP group.
Syntax: (config-int-ser-{n})# multilink-group group-number
Example: (config-int-ser-1)# multilink-group 1
Supported Platforms: Adit 3104, Adit 3200, Adit 3500
no commands
no encapsulation ppp
Use the Serial Interface no encapsulation ppp command to disable PPP encapsulation. To enable
encapsulation, see encapsulation ppp command on page 12-4.
Syntax: (config-int-ser-{n})# no encapsulation ppp
Example: (config-int-ser-1)# no encapsulation ppp
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
no firewall
Use the Serial Interface no firewall command to disable the configured firewall. To enable the
firewall, see firewall command on page 12-5.
Syntax: (config-int-ser-{n})# no firewall
Example: (config-int-ser-1)# no firewall
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
Field Definition
group-number Enter multilink group. Range = 1.