System information

12-10 Adit 3000 CLI - Release 1.6
Configuration - Serial Interface Mode
ip ospf priority
ip ospf priority
Use the Serial Interface ip ospf priority command to set the router priority, which determines the
designated router for this network. To restore the default setting of priority 1, see no ip ospf priority
command on page 12-17.
Syntax: (config-int-ser-{n})# ip ospf priority priority
Example: (config-int-ser-1)# ip ospf priority 2
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
ip ospf retransmit-interval
Use the Serial Interface ip ospf retransmit-interval command to define the interval of time between
link state advertisement retransmissions for adjacencies belonging to the interface. To restore the
default value of 5 seconds, see no ip ospf retransmit-interval command on page 12-17.
Syntax: (config-int-ser-{n})# ip ospf retransmit-interval seconds
Example: (config-int-ser-1)# ip ospf retransmit-interval 10
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
ip ospf transmit-delay
Use the Serial Interface ip ospf transmit-delay command to define the estimated time to transmit a link
state update packet on the interface. To restore the default value of 1 second, see no ip ospf transmit-
delay command on page 12-17.
Syntax: (config-int-ser-{n})# ip ospf transmit-delay seconds
Example: (config-int-ser-1)# ip ospf retransmit-interval 10
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
Field Definition
priority Enter an ID for this key. Range is 1-255.
Field Definition
seconds Range is 1-65535 seconds, with a default of 5.
Field Definition
seconds Range is 1-65535 seconds, with a default of 1.