System information
CHAPTER
12
Configuration - Serial Interface Mode
The Serial Interface Configuration commands allow the user to configure the Serial port parameters.
Enter this sub-group with the (config)# interface serial number command from the Configure mode.
The Serial Interface commands are represented by the (config-int-ser-{n})# prompt.
Serial Interface Commands
description ip primary-dns
do ip rip
encapsulation ppp ip route
end ip route-mode
exit ip secondary-dns
firewall metric
history multilink-group
ip address no commands
ip default-route ppp authentication
ip mtu ppp encryption
ip ospf authentication ppp exec-timeout
ip ospf authentication-key ppp link-fragmentation
ip ospf cost ppp on-demand
ip ospf dead-interval ppp password
ip ospf disable ppp restart-timer
ip ospf hello-interval ppp time-btwn-reconnect
ip ospf message-digest-key ppp username
ip ospf priority schedule-availability
ip ospf retransmit-interval shutdown
ip ospf transmit-delay sip-alg