System information

11-20 Adit 3000 CLI - Release 1.6
Configuration - Multilink Interface Mode
no commands
no schedule-availability
Use the Multilink Interface no schedule-availability command to disable a schedule rule. To add
a rule, see schedule-availability command on page 11-24.
Syntax: (config-int-mlink-{n})# no schedule-availability
Example: (config-int-mlink-1)# no schedule-availability
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
no shutdown
Use the Multilink Interface no shutdown command to set the Multilink port up (In-Service). To set
the interface down (Out-of-Service), see shutdown command on page 11-24.
Syntax: (config-int-mlink-{n})# no shutdown
Example: (config-int-mlink-1)# no shutdown
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
no sip-alg
Use the Multilink Interface no sip-alg command to disable SIP ALG on this interface. To enable
SIP ALG, see sip-alg command on page 11-25.
Syntax: (config-int-mlink-{n})# no sip-alg
Example: (config-int-mlink-1)# no sip-alg
Supported Platforms:
Adit 3104, Adit 3500