System information

CHAPTER
11
Configuration - Multilink Interface Mode
The Multilink Interface Configuration commands allow the user to configure the MLPPP connections.
Enter this sub-group with the (config)# interface multilink number command from the Configure
mode.
The Multilink Interface commands are represented by the (config-int-mlink-{n})# prompt.
Multilink Interface Commands
 description  ip rip
 do  ip route
 end  ip route-mode
 exit  ip secondary-dns
 firewall  metric
 history  no commands
 ip address  ppp authentication
 ip default-route  ppp encryption
 ip mtu  ppp exec-timeout
 ip ospf authentication  ppp link-fragmentation
 ip ospf authentication-key  ppp on-demand
 ip ospf cost  ppp password
 ip ospf dead-interval  ppp qos-interleaving
 ip ospf disable  ppp restart-timer
 ip ospf hello-interval  ppp time-btwn-reconnect
 ip ospf message-digest-key ppp username
 ip ospf priority  schedule-availability
 ip ospf retransmit-interval  shutdown
 ip ospf transmit-delay  sip-alg
 ip primary-dns