System information

10-26 Adit 3000 CLI - Release 1.6
Configuration - Ethernet Interface Mode
speed
speed
Use the Ethernet Interface speed command to specify the Ethernet PHY (physical specifications) speed.
Syntax: (config-int-eth-{n})# speed {10|100|auto}
Example: (config-int-eth-1)# speed 100
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
tos
Use the Ethernet Interface tos command to configure IP TOS marking. To disable TOS marking, see no
tos ip command on page 10-23.
Syntax: (config-int-eth-{n})# tos ip {enable|value hex-value}
Example: (config-int-eth-1)# tos ip value 0xff
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
Field Definition
10 10 Mbps speed .
100 100 Mbps speed.
auto Auto-negotiate the speed for the interface. Default.
Note: Setting speed to auto will set the duplex to auto.
Field Definition
enable Enable IP TOS marking.
hex-value Hex value, range 0x00-0xFF, default is 0x00