System information

Adit 3000 CLI - Release 1.6 10-21
Configuration - Ethernet Interface Mode
no commands
no ip proxy-arp
Use the Ethernet Interface no ip proxy-arp command to disable the proxy ARP on this interface.
To enable proxy ARP, see ip proxy-arp command on page 10-13.
Syntax: (config-int-eth-{n})# no ip proxy-arp
Example: (config-int-eth-1)# no ip proxy-arp
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
no ip rip
Use the Ethernet Interface no ip rip command to disable RIP on this interface. To enable RIP, see
ip rip command on page 10-14.
Syntax: (config-int-eth-{n})# no ip rip
Example: (config-int-eth-1)# no ip rip
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
no ip route
Use the Ethernet Interface no ip route command remove an IP route. To add a route, see ip
route command on page 10-15.
Syntax: (config-int-eth-{n})# no ip route dest-ip-addr gateway
Example: (config-int-eth-1)# no ip route 192.168.100.200 192.168.100.254
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
no ip secondary-dns
Use the Ethernet Interface no secondary-dns command to disable the secondary DNS. To enable
the secondary DNS, see ip secondary-dns command on page 10-16.
Syntax: (config-int-eth-{n})# no ip secondary-dns
Example: (config-int-eth-1)# no ip secondary-dns
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
Field Definition
dest-ip-addr Enter destination IP address to remove.
gateway Enter gateway IP address to remove.