System information

Adit 3000 CLI - Release 1.6 10-17
Configuration - Ethernet Interface Mode
no commands
no commands
no firewall
Use the no firewall command to disable the configured firewall. To enable the firewall, see
firewall command on page 10-4.
Syntax: (config-int-eth-{n})# no firewall
Example: (config-int-eth-1)# no firewall
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
no ip address
Use the Ethernet Interface no ip address command to remove the IP address from the alias. To set
the Ethernet IP address, see ip address command on page 10-6.
Syntax: (config-int-eth-{n})# no ip address address
Example: (config-int-eth-1)# no ip address 192.168.1.100
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
no ip default-route
Use the Ethernet Interface no ip default-route command to disable the default route. To set the
default IP address, see ip default-route command on page 10-7.
Syntax: (config-int-eth-{n})# no ip default-route
Example: (config-int-eth-1)# no ip default-route
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
no ip dhcp
Use the Ethernet Interface no ip dhcp command to disable the use of DHCP options 66 and 67 to
autoconfigure the Adit. To enable DHCP, see ip dhcp command on page 10-7.
Syntax: (config-int-eth-{n})# no ip dhcp auto-provision
Example: (config-int-eth-1)# no ip dhcp auto-provision
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
Field Definition
address Enter the IP address to remove.