System information

10-6 Adit 3000 CLI - Release 1.6
Configuration - Ethernet Interface Mode
history
history
Use the history command to display commands that have been entered in this session. Note: This
command can be entered in any configuration mode.
Syntax: (config-int-eth-{n})# history
Example: (config-int-eth-1)# history
schedule-availability rule1
history
full-duplex
ip rip
ip rip enable
ip address
speed auto
history
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
ip address
Use the Ethernet Interface ip address command to set the IP address for the Ethernet port. To remove
an IP address, see no ip address command on page 10-17.
Syntax: (config-int-eth-{n})# ip address {address mask mask [secondary]
|auto}
Example: (config-int-eth-1)# ip address 192.168.2.100 mask 255.255.255.0
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
Field Definition
address Enter an IP address to assign to the Ethernet port.
mask Enter a subnet mask for the Ethernet IP address.
auto Use DHCP to assign an IP address.
secondary This optional parameter, defines the address to be a secondary IP
address.