System information

10-4 Adit 3000 CLI - Release 1.6
Configuration - Ethernet Interface Mode
end
end
Use the end command to exit the current configuration mode, and must be used to mark the end of any
configuration file. Note: This command can be entered in any configuration mode with the same result.
Syntax: (config-int-eth-{n})# end
Example: (config-int-eth-1)# end
#
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
exit
Use the exit command to close your current connection if you are in the User mode, or Privileged mode.
If the command is entered in a subconfiguration mode (Interface or Routing), this command takes you
to the next higher level (example: back to Privileged mode from Interface configuration mode).
Syntax: (config-int-eth-{n})# exit
Example: (config-int-eth-1)# exit
(config)#
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
firewall
Use the firewall command to enable the configured firewall. To delete a preference, see no
firewall command on page 10-17.
Syntax: (config-int-eth-{n})# firewall enable
Example: (config-int-eth-1)# firewall enable
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500