System information

1-4 Adit 3000 CLI - Release 1.6
Introduction
Overview
Configure Mode
 Allows users to configure specific features/functions of the Adit.
 Use the configure terminal command to enter from Configuration Mode.
 Identified by the (config)# prompt.
Note: As the submodes change, the words inside the parentheses are modified.
 To exit Configuration Mode, the user can enter exit or press Ctrl-Z.
 Configuration Mode has various submodes:
Configuration Mode Link to Command Prompt Displayed
Controller T1 controller t1 (config-cont-t1-{n})#
DHCP server pool ip dhcp pool ethernet (config-dhcp-eth-{n})#
Dial Peer FXS dial-peer voice pots fxs (config-dpeer-fxs)#
Dial Peer Trunk dial-peer voice pots trunk (config-dpeer-trk)#
Dial Peer VoIP dial-peer voice voip (config-dpeer-voip)#
Ethernet Interface interface ethernet (config-int-eth-{n})#
MLPPP Interface interface multilink (config-int-mlink-1)#
Serial Interface interface serial (config-int-ser-{n})#
VPN IPSEC ipsec (config-ipsec)#
VPN L2TP Client l2tpc (config-l2tpc)#
OSPF router ospf (config-ospf)#
VPN PPTP Client pptpc (config-pptpc)#
VPN PPTP Server pptps (config-pptps)#
RADIUS radius-client (config-radius)#
VLAN (Global) vlan (global) (config-vlan)#
VLAN (Port) vlan (vlan-id) (config-vlan-{n})#
Voice Port (Global) voice-port (global) (config-vport)#
Voice Port (FXS) voice-port fxs (config-vport-fxs-{n})#
Voice Port (Trunk) voice-port trunk (config-vport-trunk-{n})#
Voice Service SIP voice-service sip (config-voice-serv-sip)#