System information

8-4 Adit 3000 CLI - Release 1.6
Configuration - Dial Peer Trunk Mode
end
end
Use the end command to exit the current configuration mode, and must be used to mark the end of any
configuration file.
Syntax: (config-dpeer-trk)# end
Example: (config-dpeer-trk)# end
#
Supported Platforms:
Adit 3500
exit
Use the exit command to close your current connection if you are in the User mode, or Privileged mode.
If the command is entered in a subconfiguration mode (Interface or Routing), this command takes you
to the next higher level (example: back to Privileged mode from Interface configuration mode).
Syntax: (config-dpeer-trk)# exit
Example: (config-dpeer-trk)# exit
(config)#
Supported Platforms:
Adit 3500