System information

CHAPTER
8
Configuration - Dial Peer Trunk Mode
The Dial Peer Trunk Configuration commands allow the user to configure the Dial Peer Trunk
parameters. Note: The Dial Peer Trunk option is not supported on the Adit 3104.
Enter this sub-group with the (config)# dial-peer voice pots trunk trunk dest-port command from the
Configure mode.
The Dial Peer Trunk commands are represented by the (config-dpeer-trk)# prompt.
Dial Peer Trunk Commands
 codec preference
 destination-pattern
 do
 end
 exit
 fax-protocol
 history
 modem-protocol
 no commands
 prefix
 sip-authentication
 strip-digits