System information

7-6 Adit 3000 CLI - Release 1.6
Configuration - Dial Peer FXS Mode
fax-protocol
fax-protocol
Use the Dial Peer fax-protocol command to configure the fax protocol.
Syntax: (config-dpeer-fxs)# fax-protocol {none|pass-through|t38|
t38_reserved}
Example: (config-dpeer-fxs)# fax-protocol none
Supported Platforms:
Adit 3104, Adit 3500
history
Use the history command to display commands that have been entered in this session. Note: This
command can be entered in any configuration mode.
Syntax: (config-dpeer-fxs)# history
Example: (config-dpeer-fxs)# history
history
block-out-caller-id enable
call-wait-caller-id enable
call-waiting enable
calling-party-disc enable
codec preference 1 g729
history
Supported Platforms:
Adit 3104, Adit 3500
Field Definition
none A Fax call would be treated as a normal voice call. Default.
pass-through Will cause the line to transmit in G.711 mode, with echo cancellation
and silence suppression disabled, on detection of Fax tone.
t38 Upon detection of a Fax tone on the port, will cause the gateway to
negotiate a T.38 session with its peer and if successful, will enter T.38
Fax-relay mode. Will dynamically consume a T.38 token for the
session.
t38-reserved T.38 token consumed on configuration. Otherwise, works the same a
t38 setting.