System information

Adit 3000 CLI - Release 1.6 6-7
Configuration - DHCP Pool Ethernet Mode
start-address
start-address
Use the DHCP Pool start-address command to define the DHCP start IP address. This command works
with the end-address (end IP address) to define the number of IP addresses in the DHCP pool. Which
also limits the number of hosts that may be connected to the network in this subnet. Start defines the
first IP address that may be assigned in this subnet.
Syntax: (config-dhcp-eth-{n})# start-address address
Example: (config-dhcp-eth-1)# start-address 192.168.1.1
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
static-lease
Use the DHCP Pool static-lease command to add a static DHCP lease. To delete a lease, see no static-
lease command on page 6-5.
Syntax: (config-dhcp-eth-{n})# static-lease ip-address address hostname
hostname
Example: (config-dhcp-eth-1)# static-lease ip-address 192.168.1.100
hostname www.carrieraccess.com
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
Field Definition
address The starting address of the client address pool, in the form of
xxx.xxx.xxx.xxx, where xxx is between 0-255
Field Definition
address The starting address of the client address pool, in the form of
xxx.xxx.xxx.xxx, where xxx is between 0-255
hostname Set the static lease host name