System information

CHAPTER
5
Configuration - T1 Controller Mode
The T1 Controller Configuration commands allow the user to configure the Controller parameters.
This sub-group is entered with the (config)# controller t1 command from the Configure mode.
The T1 Controller commands are represented by the (config-cont-t1-{n})# prompt.
T1 Controller Commands
 description
 do
 ds0-group
 end
 exit
 fdl
 framing
 history
 idle-pattern
 lbo
 linecode
 loopback
 loopdetect
 no commands
 pri-group
 shutdown
 tdm-group
 threshold