System information

4-52 Adit 3000 CLI - Release 1.6
Global Configuration Mode
remote-admin
remote-admin telnet
Use the remote-admin telnet command to allow remote administration to the Adit via Telnet. To
deny telnet remote access, see no remote-admin telnet command on page 4-44.
CAUTION! ALLOWING REMOTE ADMINISTRATION TO THE ADIT IS A SECURITY RISK.
Syntax: (config)# remote-admin telnet {primary-port|
primary-secure-port|secondary-port} {port port|enable}
Example: (config)# remote-admin telnet primary-port enable
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
remote-admin udp-trace
Use the remote-admin udp-trace command to allow UDP traceroute queries. To deny UDP
traceroute queries, see no remote-admin udp-trace command on page 4-44.
CAUTION! ALLOWING REMOTE ADMINISTRATION TO THE ADIT IS A SECURITY RISK.
Syntax: (config)# remote-admin udp-trace enable
Example: (config)# remote-admin udp-trace enable
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
Field Definition
primary-port Primary Telnet port, default port 23
primary-secure-
port
Secure Telnet over SSL port, default port 992
secondary-port Secondary Telnet port, default port 8023
port Enter a specific port to change from default ports listed above.
enable Enable port on telnet remote admin.