System information

Adit 3000 CLI - Release 1.6 4-23
Global Configuration Mode
ip dhcp pool ethernet
ip dhcp pool ethernet
Use the ip dhcp pool ethernet command to allow access to the DHCP configuration commands. See
Chapter 6, Configuration - DHCP Pool Ethernet Mode for commands in this mode. For the no
counterpart, see no ip dhcp pool ethernet command on page 4-40.
Syntax: (config)# ip dhcp pool ethernet port
Example: (config)# ip dhcp pool ethernet 1
(config-dhcp-eth-1)#
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
ip domain-name
Use the ip domain-name command to sets system domain name.
Syntax: (config)# ip domain-name name
Example: (config)# ip domain-name mydomain.com
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
ip host
Use the ip host command to set the host name for this device.
Syntax: (config)# ip host hostname
Example: (config)# ip host gateway1
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
Field Definition
port Selects the Ethernet port to configure. Range is 1-2.
Field Definition
name Enter the domain name of the device.
Field Definition
hostname Enter the name of the host. Default is adit3500 or adit3104 (depending
on the model of the Adit.