System information

4-18 Adit 3000 CLI - Release 1.6

Global Configuration Mode

interface multilink

Use the interface multilink command to allow access to the MLPPP configuration commands. See

Chapter 11, Configuration - Multilink Interface Mode for commands in this mode. To delete a Multilink

interface, see no interface multilink command on page 4-39.

Syntax: (config)# interface multilink group-number

Example: (config)# interface multilink 1

(config-int-mlink-1)#

Supported Platforms:

Adit 3104, Adit 3200, Adit 3500

interface serial

Use the interface serial command to allow access to the serial port configuration commands. See

Chapter 12, Configuration - Serial Interface Mode for commands in this mode. To delete a Serial

interface, see no interface serial command on page 4-39.

Syntax: (config)# interface serial port

Example: (config)# interface serial 1

(config-int-ser-1)#

Supported Platforms:

Adit 3104, Adit 3200, Adit 3500

Field Definition

group-number Enter current multilink group number. Range = 1.

Note: Currently only 1 multilink port is supported.

Field Definition

port Range is 1-4.