System information

4-10 Adit 3000 CLI - Release 1.6
Global Configuration Mode
dmz-host
dial-peer voice voip
Use the dial-peer voice voip command to allow access to the Dial Peer Voice VoIP configuration
commands. See Chapter 9, Configuration - Dial Peer VoIP Mode for commands in this mode. For
the no counterpart of this command see no dial-peer voice voip command on page 4-36.
Syntax: (config)# dial-peer voice voip trunk
Example: (config)# dial-peer voice voip 1
(config-dpeer-voip)#
Supported Platforms:
Adit 3104, Adit 3500
dmz-host
Use the dmz-host command to configure the DMZ host. To remove a DMZ host, see no dmz-host
command on page 4-36.
Syntax: (config)# dmz-host address enable
Example: (config)# dmz-host 10.10.200.1 enable
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
Field Definition
trunk Enter trunk number. Range is 1-50.
Field Definition
address The IP address of the DMZ host.