System information

Adit 3000 CLI - Release 1.6 4-9
Global Configuration Mode
dial-peer voice
dial-peer voice
dial-peer voice pots fxs
Use the dial-peer voice pots fxs command to allow access to the Dial Peer Voice FXS
configuration commands. See Chapter 7, Configuration - Dial Peer FXS Mode for commands in
this mode. For the no counterpart of this command see no dial-peer voice pots fxs command on
page 4-35.
Syntax: (config)# dial-peer voice pots fxs port
Example: (config)# dial-peer voice pots fxs 1
(config-dpeer-fxs)#
Supported Platforms:
Adit 3104, Adit 3500
dial-peer voice pots trunk
Use the dial-peer voice pots trunk command to allow access to the Dial Peer Voice Trunk
configuration commands. See Chapter 8, Configuration - Dial Peer Trunk Mode for commands in
this mode. For the no counterpart of this command see no dial-peer voice pots trunk command on
page 4-35. Note: This command is not supported on the Adit 3104.
Syntax: (config)# dial-peer voice pots trunk port dest-port
Example: (config)# dial-peer voice pots trunk 2 1
(config-dpeer-trk)#
Supported Platforms:
Adit 3500
Field Definition
port Selects the port to configure.
Adit 3104 FXS - Range is 1-24.
Adit 3500 FXS - Range is 1-4.
Field Definition
port Selects the port to configure. Trunk - Range 1-4
dest-port Set destination range. Range is 1-30.