System information

Adit 3000 CLI - Release 1.6 4-5
Global Configuration Mode
authentication login
authentication login
Use the authentication login command to use RADIUS for login authentication. To remove an
authentication login, see no authentication login command on page 4-34.
Syntax: (config)# authentication login use-radius
Example: (config)# authentication login use-radius
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
clock source
Use the clock source command to define the primary and secondary clock source.
Syntax: (config)# clock {1|2} source {none|t1 port}
Example: (config)# clock 1 source t1 2
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
controller t1
Use the controller t1 command to allow access to the Controller T1 configuration commands. See
Chapter 5, Configuration - T1 Controller Mode for commands in this mode.
Syntax: (config)# controller t1 port
Example: (config)# controller t1 1
(config-cont-t1-1)#
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
Field Definition
1|2 Sets the interface to the following clock source.
1 = Clock 1, primary clock source
2 = Clock 2, secondary clock source
none Sets the clock source to internal.
t1 port Sets the clock source to a DS1. Range is 1-4.
Field Definition
port Selects the T1 (DS1) port.
Adit 3104 Range = 1
Adit 3500 Range 1 - 4