Adit 3000 Series and Multi-Service Router (MSR) Card CLI Referece Manual

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 3-39
Privileged Mode
show interface ethernet
Use the show interface ethernet command to display the Ethernet interface information.
Syntax: # show interface ethernet port
Example: adit 3500# show interface ethernet 1
Device=Ethernet 1 State=running IP/Mask=192.168.1.1/255.255.255.0
Dependency=None
Status: Connected; Link: 10T-HD
Tx (Packets/Bytes/Dropped/Errors)=(1910/1451643/0/0)
Rx (Packets/Bytes/Dropped/Errors)=(2239/136636/0/0)
Broadcasts (Tx/Rx)=(0/0) Multicasts=0 Collisions=0
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
show interface multilink
Use the show interface multilink command to display the configuration of the Multilink.
Syntax: # show interface multilink port
Example: adit 3500# show interface multilink 1
Device=mlink-1 State=down IP/Mask=Unnumbered
Dependency=t1-1,t1-4
Status: Disconnected
Example: adit MSR# show interface multilink 1
Device=mlink-1 State=down IP/Mask=Unnumbered
Dependency=LCC1,LCC3
Status: Disconnected
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
port Port number range 1-2.
Field Definition
port Multilink port number.
Adit 3104, Adit 3200, Adit 3500: Value must be 1.
MSR: Range is 1-8.