Adit 3000 Series and Multi-Service Router (MSR) Card CLI Referece Manual

3-6 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Privileged Mode
debug portmon {rx|tx|both}
Use the debug portmon {rx|tx|both} command allows the user to monitor specific direction of
traffic.
Note: Immediately after this command is issued, any traffic that falls into the filter parameter will
be displayed. To turn the monitoring off, you must issue a no debug portmon command. See no
debug portmon command on page 3-16.
Syntax: # debug portmon {rx|tx|both}
Example: adit 3500# debug portmon both
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
debug portmon detail
Use the debug portmon detail command allows the user to configure the portmon to display brief
information or detailed. See no debug portmon command on page 3-16.
Syntax: # debug portmon detail {off|on}
Example: adit 3500# debug portmon detail on
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
both Display both receive and transmit information.
rx Display the receive direction.
tx Display the transmit direction.
Field Definition
off Disables detail packet display
on Enable detailed packet display