Adit 3000 Series and Multi-Service Router (MSR) Card CLI Referece Manual

25-14 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - Voice Service SIP Mode
redundancy advance-timeout
Use the Voice Service SIP redundancy advance-timeout command to set the interval of time before
moving onto the next proxy, when the first is not reachable.
Syntax: (config-voice-serv-sip)# redundancy advance-timeout number
Example: (config-voice-serv-sip)# redundancy advance-timeout 5
Supported Platforms:
Adit 3104, Adit 3500, MSR
redundancy filter-incoming
Use the Voice Service SIP redundancy filter-incoming command to enable filtering of packets from
unknown SIP servers. To filtering, see no redundancy filter-incoming command on page 25-10.
Syntax: (config-voice-serv-sip)# redundancy filter-incoming enable
Example: (config-voice-serv-sip)# redundancy filter-incoming enable
Supported Platforms:
Adit 3104, Adit 3500, MSR
redundancy primary-address
Use the Voice Service SIP redundancy primary-address command to configure the primary outbound
proxy.
Syntax: (config-voice-serv-sip)# redundancy primary-address address
Example: (config-voice-serv-sip)# redundancy primary-address
192.168.100.140
Supported Platforms:
Adit 3104, Adit 3500, MSR
Field Definition
number Range 0 - 10 seconds, with a default of 2.
Field Definition
address Enter the IP address of the primary outbound proxy.