Adit 3000 Series and Multi-Service Router (MSR) Card CLI Referece Manual

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 24-13
Configuration - Voice Port Trunk Mode
registration line enable
Use the Voice Port Trunk registration line enable command to enable registration. To disable
registration, see no registration line enable command on page 24-10.
Syntax: (config-vport-trk-{n})# registration line value line-numbers
value enable
Example: (config-vport-trk-1)# registration line 4 line-numbers 3 enable
Supported Platforms:
Adit 3500, MSR
registration line first-phone-number
Use the Voice Port Trunk registration line first-phone-number command to define the first
number in a block that will be registered.
Syntax: (config-vport-trk-{n})# registration line value line-numbers
value first-phone-number phone-number description description
Example: (config-vport-trk-1)# registration line 1 line-numbers 3
first-phone-number 3032185555 description turin
Supported Platforms:
Adit 3500, MSR
Field Definition
line value Enter the PBX line number to configure. Range is 1 - 300.
line-numbers value Define the number of lines in this block that are going to be registered.
Starting from the first-phone-number, increased by 1 each.
Field Definition
line value Enter the PBX line number to configure. Range is 1 - 300.
line-numbers value Define the number of lines in this block that is going to be registered.
Starting from the first-phone-number, increased by 1 each.
phone-number Enter the first number in a block that will be registered.
description Enter a description with a maximum of 20 characters.