Adit 3000 Series and Multi-Service Router (MSR) Card CLI Referece Manual

21-4 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - VLAN Port Mode
no commands
no port
Use the VLAN no port command to remove this port’s membership from the VLAN. To set the
preferences, see port command on page 21-4.
Syntax: (config-vlan-{n})# no port ethernet port
Example: (config-vlan-100)# no port ethernet 1.1
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
no voip-interface
Use the VLAN no voip-interface command to clear VLAN tagging for the originating VoIP traffic.
Syntax: (config-vlan-{n})# no voip-interface
Example: (config-vlan-100)# no voip-interface
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
port
Use the VLAN port command to set the Ethernet port as a VLAN port member.
Syntax: (config-vlan-{n})# port ethernet port
Example: (config-vlan-100)# port ethernet 1.1
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
port Ethernet port in the form {port}.{sub-interface}.
Adit 3104 and Adit 3200: 1.1, 1.2, 1.3, 1.4, 2.1
Adit 3500 and MSR: 1.1 and 2.1
Field Definition
port Ethernet port in the form {port}.{sub-interface}.
Adit 3104 and Adit 3200: 1.1, 1.2, 1.3, 1.4, 2.1
Adit 3500 and MSR: 1.1 and 2.1