Adit 3000 Series and Multi-Service Router (MSR) Card CLI Referece Manual

CHAPTER

Configuration - PPTPC Mode

The PPTPC Configuration commands allow the user to configure the VPN (Virtual Private Network)

Point-to-Point Tunneling Protocol Client parameters.

Enter this sub-group with the (config)# pptpc command from the Configuration mode.

The VPN PPTPC commands are represented by the (config-pptpc-n)# prompt.

PPTP Client Commands

• do • ip primary-dns

• end • ip rip

• exit • ip route

• firewall • ip route-mode

• history • ip secondary-dns

• host-ip • metric

• ip address • no commands

• ip default-route • ppp authentication

• ip mtu • ppp encryption

• ip ospf authentication • ppp exec-timeout

• ip ospf authentication-key • ppp on-demand

• ip ospf cost • ppp password

• ip ospf dead-interval • ppp restart-timer

• ip ospf disable • ppp time-btwn-reconnect

• ip ospf hello-interval • ppp username

• ip ospf message-digest-key • schedule-availability

• ip ospf priority • shutdown

• ip ospf retransmit-interval • sip-alg

• ip ospf transmit-delay