Adit 3000 Series and Multi-Service Router (MSR) Card CLI Referece Manual

CHAPTER

Configuration - L2TPC Mode

The L2TPC Configuration commands allow the user to configure the VPN Layer 2 Tunneling Protocol

Connection (L2TPC) parameters.

Enter this sub-group with the (config)# l2tpc command from the Configuration mode.

The VPN L2TPC commands are represented by the (config-l2tpc-1)# prompt.

L2TPC Commands

• do • ip primary-dns

• end • ip rip

• exit • ip route

• firewall • ip route-mode

• history • ip secondary-dns

• host-ip • local-secret

• ip address • metric

• ip default-route • no commands

• ip mtu • ppp authentication

• ip ospf authentication • ppp encryption

• ip ospf authentication-key • ppp exec-timeout

• ip ospf cost • ppp on-demand

• ip ospf dead-interval • ppp password

• ip ospf disable • ppp restart-timer

• ip ospf hello-interval • ppp time-btwn-reconnect

• ip ospf message-digest-key • ppp username

• ip ospf priority • schedule-availability

• ip ospf retransmit-interval • shutdown

• ip ospf transmit-delay • sip-alg