Adit 3000 Series and Multi-Service Router (MSR) Card CLI Referece Manual

14-18 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - IPSec Mode
remote-subnet
Use the IPSec remote-subnet command to set the remote subnet IP address.
Syntax: (config-ipsec-{n})# remote-subnet {none|range {start-address
address end-address address}|single ip address|subnet ip
address}
Syntax: (config-ipsec-1)# remote-subnet single ip 10.10.2.200 mask
255.255.0.0
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
schedule-availability
Use the IPSec schedule-availability command to apply a schedule rule to this connection. To reset to
the default value of "always", see no schedule-availability command on page 14-15.
Syntax: (config-ipsec-{n})# schedule-availability rule-id
Example: (config-ipsec-1)# schedule-availability rule1
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
none No IP address.
range Enter an IP address range.
start-address - Enter the start IP address of the range.
end-address - Enter the end IP address of the range.
single ip Enter a single IP address.
subnet ip Enter a subnet IP address.
Field Definition
rule-id Enter an existing schedule