Adit 3000 Series and Multi-Service Router (MSR) Card CLI Referece Manual

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 14-17
Configuration - IPSec Mode
reconnect
Use the IPSec reconnect command to enable the automatic reconnection option. To disable
reconnection, see no reconnect command on page 14-15.
Syntax: (config-ipsec-{n})# reconnect
Example: (config-ipsec-1)# reconnect
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
rekey
Use the IPSec rekey command to set the rekey lifetime, rekey margin and rekey fuzz percent.
Syntax: (config-ipsec-{n})# rekey lifetime seconds margin margin percent
percent
Example: (config-ipsec-1)# rekey lifetime 3 margin 500 percent 200
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
remote-ip
Use the IPSec remote-ip command to modify a remote tunnel endpoint address.
Syntax: (config-ipsec-{n})# remote-ip address
Syntax: (config-ipsec-1)# remote-ip 10.10.2.10
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
seconds Set the connection rekey lifetime. Range is 1-28800 seconds, with a
default of 3600.
margin Set the rekey margin number. Range is 1-540, with a default of 540.
percent Set the rekey fuzz percent. Range 1-200, with a default of 100.
Field Definition
address Enter a remote IP address.