Adit 3000 Series and Multi-Service Router (MSR) Card CLI Referece Manual

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 13-13
Configuration - Serial Interface Mode
ip route-mode
Use the Serial Interface ip route-mode command to configure the routing mode.
Syntax: (config-int-ser-{n})# ip route-mode {napt|route}
Example: (config-int-ser-1)# ip route-mode napt
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
ip secondary-dns
Use the Serial Interface ip secondary-dns command to configure the secondary DNS. To delete a
secondary DNS address, see no ip secondary-dns command on page 13-18.
Syntax: (config-int-ser-{n})# ip secondary-dns address
Example: (config-int-ser-1)# ip secondary-dns 192.168.1.200
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
metric
Use the Serial Interface metric command to configure the metric of the IP network on this interface.
Syntax: (config-int-ser-{n})# metric metric
Example: (config-int-ser-1)# metric 150
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
napt Set to NAPT mode. Default.
NAPT is used if doing private IPs on the Ethernet side or if you want
to hide specific publics on the internal side.
route Set to Route mode. Routing is used if public is visible on both sides.
Field Definition
address Enter the IP address of the secondary Domain Name Server (DNS).
Field Definition
metric Range is 0-255, with a default is 10.