Adit 3000 Series and Multi-Service Router (MSR) Card CLI Referece Manual

CHAPTER

Configuration - Serial Interface Mode

The Serial Interface Configuration commands allow the user to configure the serial interface

parameters.

Enter this sub-group with the (config)# interface serial number command from the Configuration

mode.

The Serial Interface commands are represented by the (config-int-ser-{n})# prompt.

Note: Before configuring serial interface parameters, you must enable PPP encapsulation on the

interface using the encapsulation ppp command.

Serial Interface Commands

• description • ip ospf disable • no commands

• do • ip ospf hello-interval • ppp authentication

• encapsulation ppp • ip ospf message-digest-key • ppp encryption

• end • ip ospf priority • ppp exec-timeout

• exit • ip ospf retransmit-interval • ppp link-fragmentation

• firewall • ip ospf transmit-delay • ppp on-demand

• history • ip primary-dns • ppp password

• ip address • ip rip • ppp restart-timer

• ip default-route • ip route • ppp time-btwn-reconnect

• ip mtu • ip route-mode • ppp username

• ip ospf authentication • ip secondary-dns • schedule-availability

• ip ospf authentication-key • metric • shutdown

• ip ospf cost • multilink-group • sip-alg

• ip ospf dead-interval