Adit 3000 Series and Multi-Service Router (MSR) Card CLI Referece Manual

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 2-5
User Mode
ping
Use the ping command to send a sequence of ICMP echo request packets to the specified host. If the
host variable is omitted, and you are in User mode, the router prompts you for additional information.
Note: The ping command verifies a connection, and is a very important troubleshooting tool.
Syntax: > ping {address [-i time] [-l size] [-n count]
[-w timeout]|stop}
Example: Adit 3500>
ping 192.168.1.1
packet #1 has arrived
packet #2 has arrived
packet #3 has arrived
packet #4 has arrived
4 packets transmitted, 4 packets received
round-trip min/avg/max = 1/3/9 ms
Example: Adit 3500> ping 192.168.1.1 -n 2 -l 500
packet #1 has arrived
packet #2 has arrived
2 packets transmitted, 2 packets received
round-trip min/avg/max = 2/2/2 ms
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
address IP address of the host to ping.
-i time Specifies the intervals between pings.
Range is 0 - 600000 milliseconds.
-l size Specifies the size of the ping requests packets to be sent. Range 64 -
1518.
-n count Specifies the number of ping requests to be sent.
Range 1-1000. Default is 4.
-w timeout Specifies the time to wait for a response before sending the next ping
request packet. Timeout is given in seconds. Range 1-600000. Default
is 2 seconds.
stop Stop the ping process.