Adit 3000 Series and Multi-Service Router (MSR) Card CLI Referece Manual

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 12-17
Configuration - Multilink Interface Mode
no ip ospf retransmit-interval
Use the Multilink Interface ip ospf retransmit-interval command to restore the default value of 5
seconds. To define the interval of time between link state advertisement retransmissions for
adjacencies belonging to the interface, see ip ospf retransmit-interval command on page 12-10.
Syntax: (config-int-mlink-{n})# no ip ospf retransmit-interval
Example: (config-int-mlink-1)# no ip ospf retransmit-interval
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no ip ospf transmit-delay
Use the Multilink Interface no ip ospf transmit-delay command to restore the default value of 1
second. To define the estimated time to transmit a link state update packet on the interface, see ip
ospf transmit-delay command on page 12-10.
Syntax: (config-int-mlink-{n})# no ip ospf transmit-delay
Example: (config-int-mlink-1)# no ip ospf transmit-delay
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no ip primary-dns
Use the Multilink Interface no primary-dns command to disable the primary DNS. To set the DNS
primary IP address, see ip primary-dns command on page 12-11.
Syntax: (config-int-mlink-{n})# no ip primary-dns
Example: (config-int-mlink-1)# no ip primary-dns
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no ip rip
Use the Multilink Interface no ip rip command to disable RIP on this interface. To enable RIP, see
ip rip command on page 12-11.
Syntax: (config-int-mlink-{n})# no ip rip
Example: (config-int-mlink-1)# no ip rip
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR