Adit 3000 Series and Multi-Service Router (MSR) Card CLI Referece Manual

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 11-15
Configuration - Ethernet Interface Mode
ip route
Use the Ethernet Interface ip route command to configure the static routes on this interface. To delete
a route, see no ip route command on page 11-21.
Syntax: (config-int-eth-{n})# ip route dest-ip-addr mask mask gateway
gateway metric metric
Example: (config-int-eth-1)# ip route 192.168.100.200 mask 255.255.255.0
gateway 192.168.100.254 metric 125
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
ip route-mode
Use the Ethernet Interface ip route-mode command to configure the routing mode.
Syntax: (config-int-eth-{n})# ip route-mode {napt|route}
Example: (config-int-eth-1)# ip route-mode napt
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
dest-ip-addr Enter the destination IP address.
mask Enter the mask of the above address.
gateway Enter the gateway IP address.
metric Metric of IP network on this interface in the Routing Table. Range is
0-255, with a default is 10.
Field Definition
napt Set to NAPT mode. Default. NAPT is used if doing private IPs on the
Ethernet side or if you want to hide specific publics on the internal
side.
route Set to Route mode. Routing is used if public is visible on both sides.