Adit 3000 Series and Multi-Service Router (MSR) Card CLI Referece Manual

CHAPTER

Configuration - Ethernet Interface Mode

The Ethernet Interface Configuration commands allow the user to configure the Ethernet interface

parameters.

Enter this sub-group with the (config)# interface ethernet command from the Configuration mode.

The Ethernet Interface commands are represented by the (config-int-eth-{n})# prompt.

Ethernet Interface Commands

• description • ip ospf priority

• do • ip ospf retransmit-interval

• end • ip ospf transmit-delay

• exit • ip primary-dns

• firewall • ip proxy-arp

• full-duplex • ip rip

• half-duplex • ip route

• history • ip route-mode

• ip address • ip secondary-dns

• ip default-gateway • metric

• ip default-route • no commands

• ip dhcp • release

• ip mtu • remote-admin

• ip ospf authentication • renew

• ip ospf authentication-key • schedule-availability

• ip ospf cost • shutdown

• ip ospf dead-interval • sip-alg

• ip ospf disable • speed

• ip ospf hello-interval • tos

• ip ospf message-digest-key