Adit 3000 Series and Multi-Service Router (MSR) Card CLI Referece Manual

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 10-7
Configuration - Dial Peer VoIP Mode
strip-digits
Use the Dial Peer strip-digits command to configure the number of digits (or characters) to be stripped
off from the left most digits in the phone number. Possible usages include stripping off the area code,
or the 3-digit office prefix.
Syntax: (config-dpeer-voip)# strip-digits number
Example: (config-dpeer-voip)# strip-digits 4
Supported Platforms:
Adit 3104, Adit 3500, MSR
user-id
Use the Dial Peer user-id command to configure a user ID for the line.
Syntax: (config-dpeer-voip)# user-id user-id
Example: (config-dpeer-voip)# user-id testname
Supported Platforms:
Adit 3104, Adit 3500, MSR
Field Definition
number Range is based on the defined phone number. Default is set to 0.
Field Definition
user-id Enter a user ID for the line, with a maximum of 20 characters.