Adit 3000 Series and Multi-Service Router (MSR) Card CLI Referece Manual

CHAPTER

Configuration - Dial Peer Trunk Mode

The Dial Peer Trunk Configuration commands allow the user to configure the Dial Peer Trunk

parameters.

Enter this sub-group with the (config)# dial-peer voice pots trunk trunk dest-port command from the

Configuration mode.

The Dial Peer Trunk commands are represented by the (config-dpeer-trk)# prompt.

Note: The Dial Peer Trunk option is not supported on the Adit 3104.

Dial Peer Trunk Commands

• codec preference

• destination-pattern

•do

•end

• exit

• fax-protocol

•history

• modem-protocol

• no commands

•prefix

• sip-authentication

• strip-digits