Adit 3000 Series and Multi-Service Router (MSR) Card CLI Referece Manual

8-10 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - Dial Peer FXS Mode
sip-authentication
Note: To disable this SIP authentication, see the no sip-authentication command on page 8-9.
sip-authentication enable
Use the Dial Peer sip-authentication enable command to enable SIP.
Syntax: (config-dpeer-fxs)# sip-authentication enable
Example: (config-dpeer-fxs)# sip-authentication enable
Supported Platforms:
Adit 3104, Adit 3500, MSR
sip-authentication password
Use the Dial Peer sip-authentication password command to set the SIP password.
Syntax: (config-dpeer-fxs)# sip-authentication password password
Example: (config-dpeer-fxs)# sip-authentication password
test-password
Supported Platforms:
Adit 3104, Adit 3500, MSR
sip-authentication username
Use the Dial Peer sip-authentication username command to set the SIP ID.
Syntax: (config-dpeer-fxs)# sip-authentication username username
Example: (config-dpeer-fxs)# sip-authentication username
test-user-1
Supported Platforms:
Adit 3104, Adit 3500, MSR
Field Definition
password The password to be used when responding to authentication requests.
Field Definition
username The User ID to be used when responding to authentication requests.
Default is the User ID of the line.