Adit 3000 Series and Multi-Service Router (MSR) Card CLI Referece Manual

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 8-3
Configuration - Dial Peer FXS Mode
codec preference
Use the Dial Peer codec preference command to set the codec preferences used to establish the codec
list offered during media negotiation. To delete a codec, see no codec preference command on page 8-9.
Syntax: (config-dpeer-fxs)# codec preference {1|2|3} {g711alaw|
g711ulaw|g729}
Example: (config-dpeer-fxs)# codec preference 1 g711alaw
Supported Platforms:
Adit 3104, Adit 3500, MSR
destination-pattern
Use the Dial Peer destination-pattern command to define the full telephone number to be used for a
dial peer.
Syntax: (config-dpeer-fxs)# destination-pattern number
Example: (config-dpeer-fxs)# destination-pattern 5551212
Supported Platforms:
Adit 3104, Adit 3500, MSR
Field Definition
1|2|3 Enter the preference number. #1 being the first preference.
g711alaw Set the codec preference to G.711 A-law.
g711ulaw Set the codec preference to G.711 U-law.
g729 Set the codec preference to G.729.
Note: This codec is not supported by the Adit 3500 or MSR for FXS.
Field Definition
number Enter the phone number to be used for a dial peer.