Adit 3000 Series and Multi-Service Router (MSR) Card CLI Referece Manual

6-4 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - T1 Controller Mode
ds0-group
Use the Controller T1 ds0-group command to create a group of T1s. To delete a DS0 group, see
no ds0-group command on page 6-9.
Syntax: (config-cont-t1-{n})# ds0-group timeslots range
Example: (config-cont-t1-1)# ds0-group timeslots 1-4
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
end
Use the end command to exit the current configuration mode, and must be used to mark the end of any
configuration file. This command can be entered in any configuration mode with the same result.
Syntax: (config-cont-t1-{n})# end
Example: (config-cont-t1-1)# end
#
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
exit
Use the exit command to close your current connection if you are in the User mode, or Privileged mode.
If the command is entered in a subconfiguration mode (Interface or Routing), this command takes you
to the next higher level (example: back to Privileged mode from Interface configuration mode).
Syntax: (config-cont-t1-{n})# exit
Example: (config-cont-t1-1)# exit
(config)#
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
Field Definition
range DS0 timeslot range, in the format n-n (1-4). Range is 1 - 24.