Adit 3000 Series and Multi-Service Router (MSR) Card CLI Referece Manual

CHAPTER

Configuration - LCC Controller Mode

The LCC (Link Cross-Connect) Controller Configuration commands allow the user to configure the

Link Cross-Connect parameters for the MSR card.

Note: The LCC Controller Configuration mode is supported by the MSR card only. For Controller

Configuration commands for the Adit 3000 series, see Chapter 6, Configuration - T1 Controller Mode.

This sub-group is entered with the (config)# controller lcc command from the Configuration mode.

The LCC Controller commands are represented by the (config-cont-lcc-{n})# prompt.

LCC Controller Commands

• description

•do

•end

• exit

•history

• no command

• shutdown