Adit 3000 Series and Multi-Service Router (MSR) Card CLI Referece Manual

4-58 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Global Configuration Mode
Global Configuration Commands
security-log
Use the security-log command to configure the security policy. To delete a security policy, see no
security-log command on page 4-49.
Syntax: (config)# security-log setting enable
Example: (config)# security-log accepted-out-connection enable
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
Accepted Events
accepted-in-connections Sessions originated from the Internet that have been allowed by
the firewall.
accepted-out-
connections
Sessions originated from the network that have been allowed by
the firewall.
Blocked Events
blocked-conn-attempts Sessions that have been blocked by the firewall.
blocked-fragments Detection of fragmented packets when Block IP Fragments is
enabled.
defrag-error Detection of fragmented packets that cannot be properly
reassembled.
echo-chargen Detection of the Echo or Chargen DOS attacks.
icmp-flood Detection of an ICMP flood DOS attack.
icmp-multicast Detection of multicast ICMP packets, such as a ping to a subnet
broadcast address.
icmp-redirect Detection of improper ICMP redirect messages from the WAN.
icmp-replay Detection of an ICMP Replay DOS attack.
multicast-broadcast Detection of the Multicast or broadcast packets arriving at the
WAN interface.
pkt-illegal-opts Detection of IP packets with disallowed IP options: lsrr, ssrr, rr,
timestamp, or error options.
spoofed-connection Detection of IP address spoofing attacks.
syn-flood Detection of the Syn Flood DOS attack.
udp-flood Detection of a UDP Flood attack.
winnuke Detection of the Winnuke DOS attack.
Other Events
connection-states Session connection state detail.
rem-admin-attempts Management sessions established.
Log Buffer
prevent-log-overrun Stop logging firewall detail when the log is full. This prevents
loosing early log entries, but will drop the later log entries.