Adit 3000 Series and Multi-Service Router (MSR) Card CLI Referece Manual

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 4-25
Global Configuration Mode
Global Configuration Commands
ip dhcp pool ethernet
Use the ip dhcp pool ethernet command to allow access to the DHCP configuration commands. See
Chapter 7, Configuration - DHCP Pool Ethernet Mode for commands in this mode. For the no
counterpart, see no ip dhcp pool ethernet command on page 4-43.
Syntax: (config)# ip dhcp pool ethernet port
Example: (config)# ip dhcp pool ethernet 1
(config-dhcp-eth-1)#
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
ip domain-name
Use the ip domain-name command to sets system domain name.
Syntax: (config)# ip domain-name name
Example: (config)# ip domain-name mydomain.com
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
ip host
Use the ip host command to set the host name for this device.
Syntax: (config)# ip host hostname
Example: (config)# ip host gateway1
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
port Selects the Ethernet port to configure. Range is 1-2.
Field Definition
name Enter the domain name of the device.
Field Definition
hostname Enter the name of the host. Default is adit3500, adit3104, or aditMSR
(depending on the platform).