Adit 3000 Series and Multi-Service Router (MSR) Card CLI Referece Manual

4-20 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Global Configuration Mode
Global Configuration Commands
interface multilink
Use the interface multilink command to allow access to the MLPPP configuration commands. See
Chapter 12, Configuration - Multilink Interface Mode for commands in this mode. To delete a Multilink
interface, see no interface multilink command on page 4-42.
Syntax: (config)# interface multilink group-number
Example: (config)# interface multilink 1
(config-int-mlink-1)#
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
interface serial
Use the interface serial command to allow access to the serial interface configuration commands. See
Chapter 13, Configuration - Serial Interface Mode for commands in this mode. To delete a serial
interface, see no interface serial command on page 4-42.
Syntax: (config)# interface serial port
Example: (config)# interface serial 1
(config-int-ser-1)#
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
group-number Enter multilink group number.
Adit 3104, Adit 3200, Adit 3500: Value must be 1.
MSR: Range = 1-8.
Field Definition
port Adit 3104: Value must be 1.
Adit 3200, Adit 3500: Range = 1-4.
MSR: Range = 1-8.