Adit 3000 Series and Multi-Service Router (MSR) Card CLI Referece Manual

4-4 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Global Configuration Mode
Global Configuration Commands
access
Use the access command to enable remote access via LAN or WAN. To disable remote access, see no
access command on page 4-36.
Syntax: (config)# access {lan|wan} enable
Example: (config)# access lan enable
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
access-control
Use the access-control command to configure an access (scheduler) rule for the system. To remove a
rule, see no access-control command on page 4-36.
Syntax: (config)# access-control name apply-to {lan|object-name}
time-range {always|schedule-id} service service-id
Example: (config)# access-control AccessControl_1 apply-to lan time-range
always service 16777220
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
lan Enable remote access via the LAN.
wan Enable remote access via the WAN.
Field Definition
name Enter a name for the Access Control (Scheduler Rule), with a
maximum of 64 characters.
lan Apply this scheduler rule to the LAN interface.
object-name Enter the Network Object name to apply the rule to.
always Apply this rule always. Default.
schedule-id A configured schedule to apply this rule.
service-id Enter the service number to apply the rule to.
Note: The Service ID number can be found with the show service
command, on page 3-61