Access Navigator User Manual

Access Navigator - Release 1.8 August 2003 6-35

Electrical Installation

DC Power Connections

Installation Summary

n Precautions ... 6-35

n Tools and Materials ... 6-35

n Wire Power Connectors ... 6-36

n Verify Wiring ... 6-37

n Connect Power Plugs to Access Navigator ... 6-37

Precautions

DANGER! HIGH VOLTAGE SHOCK HAZARD. DO NOT WIRE CONNECTORS WHILE

POWER IS ON.

CAUTION! BOTH POWER CONNECTORS MUST BE WIRED AND CONNECTED TO

POWER SOURCES. FAILURE TO DO SO WILL DISABLE REDUNDANT SWITCHING FEATURES

AND MAY INTERRUPT SERVICE.

WARNING! POWER INPUT CONNECTORS ARE FOR –48V DC POWER ONLY.

Tools and Materials

NOTE: If the power connector is wired to a fuse panel, use a 5.0 Amp slow-blow fuse.

Obtain the following tools and materials:

• Pliers, needle nose

• Cutters, diagonal

• Wire stripper, 16-26 AWG

• Continuity tester

• Volt-ohm meter

• 16 or 18 AWG insulated copper wire for power connections, as required by standard wiring

practices