Access Navigator User Manual

Access Navigator - Release 1.8 August 2003 6-27

Electrical Installation

Alarm Output Connections

Installation Summary

n Precautions ... 6-27

n Tools and Materials ... 6-27

n Wire Alarm Output Connector ... 6-28

n Plug Output Alarm Connector into Access Navigator ... 6-30

Precautions

DANGER! OBSERVE EXTREME CAUTION IF FACILITY ALARM SYSTEM USES HIGH

VOLTAGE.

WARNING! DO NOT EXCEED MAXIMUM RELAY CONTACT RATINGS OF 1 AMPERE AT

110

VOLTS AC OR DC. EXCESSIVE CURRENT OR VOLTAGE WILL DAMAGE THE RELAY

CONTACTS IN THE ACCESS NAVIGATOR.

Tools and Materials

Obtain the following tools and materials:

• Pliers, needle nose

• Cutters, diagonal

• Wire stripper, 16-26 AWG

• Continuity tester

• Volt-ohm meter

• 16 to 26 AWG insulated copper wire for alarm connections, as required by standard wiring

practices