Dimensions Guide
C
B
A
F
1) Insert the Receiver Bar (F) into the
carrier’s Angle Plate (G) from the
opposite end of the CARPOD® sticker.
2) Align the carrier Angle Plate holes
with the Receiver Bar holes.
3) Insert the four Hex Bolts (C) through
the carrier Angle Plate and the Receiver
Bar.
4) Slide the Lock washer (B) over the
Hex Bolt.
5) Place the Hex Nylock Nut (A) on Hex
Bolts (C) and tighten.
D
1) One by one open sidewalls to a
vertical or open position.
2) Insert all four Cotterless Pins (D) into
corner hinges.
4) When closing the sidewalls reverse
the opening process.
CAUTION: When erecting/opening
sidewalls DO NOT release them to
free-fall.
Wrap the Top Belt (E) around the top
center part of the two large sidewalls
and tighten slightly until snug.
E
G
G
If exhaust heat blows directly onto cargo, position load away from it. Be aware of the
possible risk of re and damage to property resulting from the vehicle’s exhaust pipe
pointing at the cargo. Flammable cargo can ignite from exposure to heat. Always be aware
of this potential danger, and never use the Cargo Carrier if this risk exists. If Carpod carrier
does not t on your vehicle do to the hitch position, a hitch adapter can be used. To divert
exhaust or move cargo away from it, a hitch adapter/riser or turndown exhaust tip may be
used. Make sure all hardware connections are secure before each use.
Open position 22” H, 48 3/4“ W, 24” D
Folds to a height of 5 1/4”
Weight 49 Lbs
Maximum Base Load Capacity 450 Lbs
Cargo Capacity 13 1/4 cubic feet
CARPOD® Water Resistant Cargo Bag
Item Number: M2202
CARPOD® Lockable Top Lid
Item Number: M2201
Carpod Inc. Warrants all parts of Carpod® Cargo Carrier product to be free from defects
in material and workmanship for a period of 90 days from date of purchase. Within this
period, Carpod Inc. shall correct any defect by repairing or replacing any defective parts
of the equipment, or making available parts thereof, FOB Los Angles, CA.
Carpod Inc. has the sole responsibility to verify and conrm if a part is defective. Carpod
Inc. shall not be obligated to repair or replace equipment which has been repaired by
others, abused, altered or misused. We further state that we shall not be held liable for
any losses due to neglectful use on the part of the operator. Upon expiration of such
warranty, all liability shall terminate. No other warranties are expressed or implied.
NOTE: Paint nish will scratch and chip under normal use, and therefore will not be
covered under the warranty policy.
WARRANTY
Sold Separately
CARPOD ACCESSORIES
IMPORTANT NOTICE